Product Details:
Material | M2,M35 |
Color | Silver & Gold |
Usage/Application | Through hole |
Brand | Totem, Addision, Miranda |
Features | Radial and axial through coolant taps |
Grade | M2,M35 |
Shape | Various |
Straight flute taps dimensionally same as hand taps & with a lead chamfer of 1.1/2 threads. The flute & rake angle are designed as per application.
These Taps are recommended for tapping on grey cast iron, S G iron & steel. The chips produced are short or powder type with the help of special design provided in the tap
Product Details:
Material | HSS |
Usage/Application | INDUSTRIAL USE |
Surface Finishing | Polished |
Color | Silver & Gold |
Brand | Totem,Addision,Miranda |
Hardness | 60-70 HRC |
Forming Taps otherwise known as Roll, Fluteles or Polygon taps. Used for the chipless production of threads in ductile materials such as copper, aluminium, soft brass or steel. Threads produced by fluteless taps are formed by plastic deformation, they are not cut.
These taps do not have flute or cutting edges but have special roll forming lobes with circular land. They are operated at high speeds and are better at maintaining gauge qualification.
Because they produce no chips they are very suitable for blind hole application as well as through hole application.
Product Details:
Color | Silver & Gold |
Usage/Application | Industrial use |
Brand | Totem , Miranda, Addision |
Features | Chips are pushed upwards due to spiral flute - Chip clogging avoided |
Shape | Various |
Tensile Strength | 370Mpa |
SPIRAL FLUTE – These taps are used to produce a thread close to the bottom of a blind hole and therefore have a very short lead.
The right hand spiral cut of the flutes acts to force the swarf away from the cutting teeth to the rear of the flutes and out of the hole. They are better on materials which form long continuous stringy swarf, rather than chips.
They are also better to tap a thread in a hole where there is a break in the material, e.g. another hole, as the spiral fluting helps the tap to pick up on the other side. Spiral flute taps can have slow or fast helix angles.
Product Details:
Color | Silver & Gold |
Usage/Application | Industrial use |
Surface Finishing | Polished |
Brand | Totem, Addision, Miranda |
Diameter | 1.6mm to 120mm,1/16inch to 3inch |
Shape | Various |
Spiral Point Taps is also known as gun nose or bull nose or chipdriver. These taps are dimensionally the same as a hand tap, second lead, but have the cutting face ground back relative to the axis of the tap, for the lead portion.
This gives the flute a better cutting action, requiring less power, and pushes the cut material forward, allowing free flow of coolant along the flutes to the cutting edge.